Section 05
ENGINE (4-TEC)
Subsection 06
(PTO HOUSING/MAGNETO)
05-06-4
SMR2002_070_05-06A.FM
Position the disc springs
no. 6
and washer
no. 7
as per the following illustration.
1. Washer
2. Disc spring
3. Flange washer
4. Starter drive ass’y
CAUTION:
Ensure the starter drive gear shaft is
well engaged in its bore.
Gently install PTO housing.
CAUTION:
While installing housing, pay partic-
ular attention that gasket does not get pinched
or slide out of its contact surface in the area
shown in the following illustration. Never force
to install cover. If there is a strong resistance,
remove housing and check oil/coolant pump
alignment and starter gear alignment.
1. Pay attention that gasket remains properly positioned on this
surface.
Refer to the following illustration for proper instal-
lation of screws.
1. Screws M6 x 35
2. Screws M6 x 85
Tightening sequence for screws on PTO housing
is as per following illustration.
Reinstall LH engine support. Apply Loctite 243 (blue)
on screw threads then torque to 24 N•m (17 lbf•ft).
Remove block under engine.
Properly reinstall chain tensioner. Refer to ENGINE
BLOCK subsection.
Properly reinstall valve cover. Refer to CYLINDER-
HEAD AND VALVES subsection.
Refill engine with oil and cooling system with coolant.
Refer to ENGINE and COOLING SYSTEM sections.
Check engine alignment. Refer to REMOVAL AND
INSTALLATION in ENGINE section.
R1503motr46A
1
2
3
4
1
F18D2LA
R1503motr15A
1
1
1
2
2
2
2
2
R1503motr15B
14
15
16
17
18
19
20
21
2
3
4
5
6
7
8
9
10
11
1
12
13
www.SeaDooManuals.net
Summary of Contents for GTX 4-TEC 5573 2002
