Scientific Atlanta PowerVu D9234, Installation And Operation Manual

Page: 14 / 78

This section provides information about setting up and installing your new Busi-
ness Satellite Receiver, or for modifying your current equipment installation.
8QSDFNLQJ\RXUUHFHLYHU
Before you proceed with unpacking the equipment, inspect the shipping carton for
damage. If damage is apparent, do not proceed with unpacking and report the
damage immediately to the shipper or your retailer. If there is no apparent dam-
age, remove the contents from the carton and protective packaging. Retain the
packaging in the event of return, or for equipment storage.
After unpacking your Business Satellite Receiver, check that you have also received
the following accessories:
‰ One IR (Infra-Red) Remote Control transmitter
‰ Two size AA batteries
,QVWDOOLQJWKH5HPRWH&RQWUROEDWWHULHV
Before you can use the Remote Control transmitter to operate your Business Satel-
lite Receiver, the two size AA batteries must first be installed. The batteries can
supply power for up to several months, depending on how often the Remote Con-
trol is used. If the Remote Control does not appear to be operating properly, the
batteries may require replacement. When replacing the batteries, it is important to
use only those of the same type and rating. Always dispose of exhausted batteries
in a safe manner. If the Remote Control is not being used for an extended period of
time, it is recommended that the batteries be removed. For more information about
your Remote Control transmitter, see “Remote Control functions”.
Your Business Satellite Receiver comes equipped with a Remote Control transmit-
ter. An optional AllTouch Remote Control transmitter is available which can be
programmed to operate your TV, Scientific-Atlanta Home Communications Termi-
nal or cable box. For Remote Control battery removal and replacement, see the fol-
lowing instructions.
To install batteries in the Remote Control transmitter
1. Remove the battery compartment cover from the Remote Control case (rear) by
sliding the tab away from the case in the direction of the arrow
(see Figure 2).
2. Remove the old batteries from the battery compartment.
3. Noting the polarity, install new batteries of the same size, type and rating into the
battery compartment and replace the cover.
4. Check the operation of the Remote Control with the new batteries.
6HWXSDQGLQVWDOODWLRQ
Figure 2. Remote Control transmitter case (rear) showing battery compartment