Scientific Atlanta PowerVu D9234, Installation And Operation Manual

Page: 30 / 78

To set the Symbol Rate
Step 1. Move to Symbol Rate and press SELECT to replace the current setting.
Step 2. Enter a valid Symbol Rate using the numbered Remote Control buttons and
then press SELECT. You can also press the
Ï / Ð arrow buttons to display
available settings (Symbol Rates are displayed from 3 MS/s through 30.8000
MS/s in 10 KS/s steps). The default setting is 28.3465 MS/s.
Step 3. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 4. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another Symbol Rate. The selected Symbol Rate
must match the Symbol Rate associated with the transmitted signal. If you are un-
sure about which Symbol Rate to use, contact your dealer/reseller, or local service
provider.
To set the Network ID
Step 1. Enter a valid Network ID (number) and then press SELECT. You can also press
the
Ï / Ð arrow buttons to display available settings (numbers are displayed
from 0 through 65535).
Step 2. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 3. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change the Network ID (see also “
}
About the Network ID”).
Changing the Network ID is normally required only when authorized subscriber
services are changed, or when new or different subscriber services are made avail-
able (see Figure 9). If you are unsure about which Network ID to use, contact your
dealer/reseller, or local service provider. Changing the Network ID may also re-
quire that you execute a signal search (see “Search Setup menu”
and “…About the
Find option”).
« $ERXWWKH6LJQDO6WDWH
During normal operation, your receiver is synchronized with the received LNB
signal (confirmed by the “
Lock, Sig “ status display). If the receiver is able to syn-
chronize to a carrier frequency only and no MPEG stream is present or is recog-
nized, the “
Lock, No Sig “ status is displayed, and the Signal indicator LED is OFF. If
no digital carrier signal is detected, the “ No Lock “ status is displayed, and the Signal
indicator LED is also OFF. If a signal search activated using the “Find” option is in
progress, the “
Searching “ status is displayed. If a signal search activated using the
Search function is in progress, the message “ Searching for a signal “ is displayed. For
more information about the Find option, see “…About the Find option”. For more
information about signal searches, see “
}
About the Search option”.
« $ERXWWKH)LQGRSWLRQ
Searching for a signal with the “Find” option can be used if you are installing your
Business Satellite Receiver for the first time, or if you are modifying the current
receiver setup. Activating the Find function forces the receiver to search for a signal
immediately. Signal searches are also performed automatically to restore normal
receiver operation if the received signal is interrupted or lost, or is changed by the
local broadcast satellite services provider.