Scientific Atlanta PowerVu D9234, Installation And Operation Manual

Page: 4 / 78

4XLFN6HWXSLQVWUXFWLRQV
Follow these quick setup instructions to find a signal using the BSR built-in signal
search function.
Step 1. Display the BSR MAIN MENU by pressing MENU.
Step 2. Display the RECEIVER STATUS menu by pressing 2 and then SELECT, or
move to Receiver Status and press SELECT.
Step 3. Display the RECEIVER SETUP menu by pressing 3 and then SELECT, or move
to Receiver Setup and press SELECT.
Step 4. Enter the Local Oscillator #1 Frequency (in GHz) based on C or Ku-Band
LNB/F operation and press SELECT (e.g., 10750 for Ku-Band, and 5150 for C-
Band).
Step 5. Enter the Symbol Rate (in MS/s) and press SELECT.
Step 6. Display the correct FEC Rate and press SELECT.
Step 7. Activate the signal search to “Find” the signal by moving to Find and
pressing SELECT (set to ON).
The “
Lock, Sig ” Signal State is displayed when a signal is found.
Step 8. Save the settings: (after signal found)
(a) Move to Exit and press SELECT (or press 1 and then SELECT) to display the
Save pop-up menu.
(b) Press 1 to save the new configuration (YES).
When the signal is found, the Find option is automatically set to OFF. You can also
terminate the search manually by setting the Find option to OFF. Repeat this action
to search for another signal. If no Remote Control is available, you can perform the
these functions using the following front panel buttons.
‰ Save: Press and hold down both the Í and Î arrow buttons simultaneously (5) to
save the new configuration (YES)
‰ Discard: Press and hold down both the Ï and Ð arrow buttons simultaneously (4)
to discard all changes (NO)
‰ Cancel: Press SELECT (3) to cancel the operation (CANCEL)
«$ERXWIDFWRU\GHIDXOWVHWWLQJV
Factory default settings can be modified at any time. A Factory Reset option is also
available for replacing the current settings with the factory defaults (see Table A).
Table A. Factory default settings
Option Menu Default setting
1. Frequency Mode Receiver Setup L-Band/1
2. Frequency Receiver Setup 950 MHz
3. Local Oscillator #1 Receiver Setup 9.750 GHz
4. Local Oscillator #2 Receiver Setup 10.600 GHz
5. Crossover Receiver Setup 11.700 GHz
6. Polarization Receiver Setup H (Horizontal)
7. FEC Rate Receiver Setup 7/8
8. Symbol Rate Receiver Setup 28.3465 MSymbols/s
9. Network ID Receiver Setup 1
10. Lock Level User Setup 0
11. Bouquet ID User Setup 0
12. TV Audio User Setup Left + Right
13. Baud Rate User Setup 9600
14. Aspect Ratio User Setup Normal
15. Local Time User Setup 12:00 AM
16. IR Remote User Setup Enabled
17. Date Format User Setup US
18. Video Standard User Setup AUTO
19. Subtitles Language User Setup OFF
20. Password User Setup 1 2 3 4
21. Search Mode Search Setup OFF
22. Search Type Search Setup Frequency
23. Lower Range Search Setup 950 MHz
24. Upper Range Search Setup 2150 MHz
25. IQ Select Search Setup Automatic
26. UHF Channel Setting 38
WARNING! Saved settings are automatically restored when the receiver is
restarted after AC power is switched off or interrupted. Upon restarting, the
receiver defaults to the last virtual channel displayed for more than 20 sec-
onds after exiting from menus (see also ““
} About saving changes“ in the
Installation and Operation Guide).