Scientific Atlanta PowerVu D9234, Installation And Operation Manual

Page: 39 / 78

} $ERXWRWKHU6HDUFK6HWXSRSWLRQV
Signal searches are constrained or limited by the current Search Type and the
boundary settings for the Lower and Upper Range. When searching for a signal,
the receiver uses the Search Type as the primary search criteria. For example, if the
FEC Rate is set as the Search Type, only signals that match the current FEC Rate
(set at the Receiver Setup menu) within the current Lower/Upper Range frequency
boundaries are examined for a possible match. Signals associated with all other
FEC Rates are ignored (see also “
}
About I/Q signal inversion”).
To set the Search Mode
Step 1. Move to Search Mode and press SELECT to display available settings (ON or
OFF). The default setting is OFF.
Step 2. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 3. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Setting the Search Mode to ON enables the signal search for automatic activation.
You can disable the signal search option by setting the Search Mode to OFF.
To set the Search Type
Step 1. Move to Search Type and press SELECT to display available settings
(see Table 8). The default setting is Frequency.
Step 2. When the desired setting is displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current setting.
A pop-up menu displays Save options.
Step 3. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Table 8. Available Search Type options
Option Description
FEC Rate Search by FEC Rate
Frequency Search by Frequency
Repeat the above action to change the Search Type. If you are unsure about which
Search Type to use for best results, contact your dealer/reseller, or local service
provider.
To set the Lower and Upper frequency ranges for the search
Step 1. (a) Move to Lower Range and press SELECT to replace the current setting.
(b) Enter a valid frequency and then press SELECT. You can also press the Ï / Ð
arrow buttons to display available settings (frequencies are displayed in 250
kHz steps from 950 through 2150 MHz). The default setting is 950 MHz.
Step 2. (a) Move to Upper Range and press SELECT to replace the current setting.
(b) Enter a valid frequency and then press SELECT. You can also press the Ï / Ð
arrow buttons to display available settings (frequencies are displayed in 250
kHz steps from 950 through 2150 MHz). The default setting is 2150 MHz.
Step 3. When the desired settings are displayed on-screen, move to Exit and press
SELECT, or press 1 and then press SELECT to change the current settings.
A pop-up menu displays Save options.
Step 4. Press 1 to save the new setting (YES), or follow the on-screen instructions, as
required.
Available options: Press 1 to save the new settings (Yes), or press 2 to discard all
changes (No), or press 3 to cancel the operation (Cancel).
Repeat this action to change to another frequency. If you are unsure about which
frequencies to use, contact your dealer/reseller, or local service provider.