SAMWONTECH
2nd Edition of TEMP2000M_Series IM : April. 8. 2014 Page 6 / 176
1.2 Exterior and how to install
1.2.1 Installation location and environment
A
Cautions in installation location and environment
u
(A)
Handle after switching on at the state of installing this product on the panel because there is
a risk of electric shocking. (Cautions for electric shocking)
(B)
Do not install this product at the following location and environment.
■
A place where a person can touch the terminal point without recognition
■
A place exposed directly to the mechanical vibrato or impact
■
A place exposed to the corrosive gas or combustible gas
■
A place with big temperature change
■
A place with excessive high (Over 50℃) or low (Under 10℃) temperature
■
A place exposed directly to the direct sunlight
■
A place influenced by electromagnetic wave
■
A place with high humidity (A place over 85% of ambient humidity)
■
A place where the flammable stuffs are placed at the surrounding.
■
A place with many dust or salts
■
A place exposed to the ultra violet light
☞
Even though the case of this product is made of non-flammable material such as
ABS/PC, do no install at the place where the flammable stuffs exist.
음
Cautions in installaiton
음
(A)
Do not place the device or wire which become the cause of the noise near to this product
(B)
Use the product within 10~50℃, 20~90% RH(The dew shall not be made).
Especially, do not place the excessive heating device at near
(C)
Do not install the product in declining.
(D)
Keep the product within -5~70℃, 5~95%RH (The dew shall not be made).
(E)
Especially, use after full warming up when it is used in under 10℃.
(F)
Make wiring after switching off of every device during the wiring (Cautions in electric shock)
(G)
This product operates in 24V DC, 22VAmax without special manipulation.
There is a risk of the electric shock and fire when it is used in the abnormal electric source
(H)
Do not work with wet hand. There is a risk of the electric shock.
(I)
Keep the basic cautions to reduce the fire, electric shock and risk of injury in use.
(J)
Install and use according to the instructions on the installation manual.
(K)
Refer to the installation instruction for the necessary information for the ground. However,
do not ground to the water pipe, gas pipe, phone line and lightening rod. There is a risk of
explosion and ignition.
(L)
Do not switch on before connection of the devices of the product. It may cause the failure.
(M)
Do not close the ventilation hole on the product. It may cause the failure.
(N)
Do not decline the I/O BOARD and install inside the hygrostat. Use after fixing on the holes
on the board with bolts and nuts.
(O)
The level of excessive voltage is category
Ⅱ and the use environment is
DEGREE
Ⅱ.
Summary of Contents for 3ch series
Page 1: ...Instruction Manual ...
