Sam4s SAM4POS, Program Reference Manual, Page: 108 / 350

108
•
Program Mode Sam4POS 6600/4800II Program Manual v2.12
Tax Table Programming
In some cases, a tax that is entered as a percentage does not follow exactly the tax charts that apply in
your area (even if the tax chart is based on a percentage). In these cases, we recommend that you
enter the tax rate using tax table programming method. This method will match tax collection exactly
to the break points of your tax table.
Option - General
SPECIFICATION
Select TAX TABLE from the drop-down selection menu.
RATE
You can enter the rate if desired, this has no effect on the tax table values entered.
Option – Tax Table Option
MAXIMUM NON-TAXABLE AMOUNT
Enter the highest amount where no tax is charged. For this example, the entry is 0.10.
FIRST TAX AMOUNT CHARGED
Enter the first tax amount that is charged. For this example, the entry is 0.01.
# OF NON-REPEAT BREAKS
Enter the number of Non-repeat breaks. For this example, the entry is 5.
# OF REPEAT BREAKS
Enter the number of repeat breaks. For this example, the entry is 3.
BREAK POINT
Enter the high amount in the range.
For example: if the break point is .22 - .38, enter .38 for the break point.
Break Point
The break point tab is where the tax table break points are entered. The Sam4POS uses the high-side
of the breakpoint range. Refer to the tax chart from your state department of revenue for the tax
appropriate tax breaks for the tax rate you are entering. Use the buttons at the bottom of the display to
enter your values.
1. To enter the breaks for the tax table – press the New button; enter the first break point (high-side break
point) for the specified number of Non-Repeat and Repeat Breaks from the tax table chart.
2. Enter the first Non-Repeat break point value and press OK And Continue .
3. Continue entering all the Non-Repeat and Repeat Break points in the same manner. After the last
Repeat Break is entered, press
OK .
4. If an incorrect break point value was entered, you can select the break point and press the EDIT button
to change the value.
5. You can delete selected break points with the DELETE button.