- 10 -
MF 5990 - Agoris M943
2 - Installation
6
Fan the paper and even it up on a flat surface to
prevent paper jams or skewed prints.
7
Load the sheets into the paper tray with the print
surface facing up.
8
Make sure the paper does not exceed the fill limit.
9
Replace the cover on the paper tray. Ensure that
the cover is properly closed.
10
Replace the paper tray in the machine and push it
in fully.
11
Define the paper format and type used in the ma-
chine.
The machine automatically detects standard paper
formats. To check / define the format and type of pa-
per loaded, consult the section Paper settings [
25].
Loading paper format larger than A4
The procedure for loading paper described in this section
applies to all paper trays in the machine.
1
Remove the paper tray from the machine and place
it on a flat surface.
2
Remove the cover from the paper tray.
3
Unlock the two catches by sliding them towards the
outside.
4
Pull the extendable part of the paper tray by taking
hold of the handle and pulling it to the required pa-
per format.
Note
The loading capacities depend on the paper
tray used:
- main / additional paper tray: up to 550
sheets of standard paper (80g/m² [22lb])
- secondary paper tray: up to 150 sheets
of standard paper (80g/m² [22lb])
Note
If you are using paper format smaller than
A4, see the section Loading paper in the
paper tray [
9].
If you are using transparencies, see the
section Loading transparencies into the
paper tray [
11].
