R5
SUPREME - Navigation System
SLAVE DISPLAYS AND REDUNDANT SYSTEMS
7000 118-383, P11A1
Page 116
11.2 Redundant Navigation Systems
In a redundant setup, each R5 SUPREME CDU shall be connected a separate R5 Navigation
Sensor, by a common network, which provides the GNSS data. The common network is also
need for the R5 SUPREME CDUs in order to synchronize configuration parameters, waypoint
and route databases as well as the active route. This section describes how the R5
SUPREME Navigation Systems should be configured for the redundant setup to work
properly. The following steps should be done on each R5 SUPREME Navigation System in
the redundant setup:
Connect all the R5 SUPREME CDU and the R5 Navigation Sensors to a common
network, by a network switch for example, and make sure it is powered.
Make sure that the all connected units has a configured IP address and a unique LWE
ID. These parameters can be viewed and configured from
Main Menu
Maintenance
Configuration
Interface
Network
Own CDU Settings /Navigation Sensor
Settings
Figure 108
–CDU Network Settings
The R5 SUPREME CDU must now also find all other R5 SUPREME Navigation Systems
on the LWE network in order to synchronize configuration, waypoints, active route and
route lists. This is done in the
Redundant Nav Config
view accessed from
Main Menu
Maintenance
Configuration
Interface
Network
Redundant Nav
.
Figure 109
– Redundant Nav Config
