73
Material Type
Figure 86
Material Type Options
There are three material type options to select:
Media Edge Detection
Figure 87
Media Edge Detection Options
The following table describes media edge detection options:
Material Type
Die-cut with gaps (label material)
Continuous
Tick marks on back (also known as blackmark)
Edge
Detection
Description
Automatic
Edge detection relying on the printer sensors.
Supervised
The liner-label distance (the distance between the liner edge and the
label edge in millimeters) can be set. In this case liner edge is
detected and the liner-label distance is added to it resulting the final
left offset of the print job.
NOTE
: This option is media dependent and should be updated each
time a media with different liner-label distance is used. The liner edge
detection is usually more stable and therefore in this case the whole
detection might be more stable. This mode can be also be used for
non-die-cut materials where a left offset adjustment is needed.
Turn off
Turns the left offset sensor off and lets the operator to give the
left offset manually (in millimeters).
