Reader Functionality
•
The Reader status LED flashes orange
.
4. Present the user’s card or enter the user’s PIN code
•
If the card or PIN code is not found, the unit sounds a long
beep. Present a different card or enter a different PIN code.
•
If the card or PIN code you entered is found, the Reader status
LED flashes green
.
5. Enter your programming code to confirm the deletion.
If the programming code is valid, the unit sounds three beeps and the
AYC-W6500 returns to Normal Access Mode.
If the programming code is invalid, the unit sounds a long beep and
the AYC-W6500 returns to Normal Access Mode.
PIN Code Length / Factory Default Settings
Use this command to erase all user codes, reset all operation codes to
their factory settings and to specify a new PIN code length.
Any user codes, PIN codes or fingerprints that have already been stored in
the system will be permanently erased.
Warning:
Use this function with extreme care!
This function erases the unit's memory entirely and resets all
codes to their factory default settings.
Note:
Option 8, setting length to 4-8 digits is invalid if Multiple keys,
Wiegand 26 bit option of transmission format (1-0) is selected
To Set PIN Code Length and Reset to Factory Default Settings:
1. Enter
Programming
Mode
(see
Entering Programming Mode,
page 17).
2. Select the desired PIN code length as follows:
00 - Returns to factory defaults and sets a 4 digit code.
05 - Returns to factory defaults and sets a 5 digit code.
06 - Returns to factory defaults and sets a 6 digit code.
08 - Returns to factory defaults and sets a 4-8 digit code.
Page 29
AYC-W6500 Installation Manual
