Reader Functionality
AYC-W6500 Installation Manual
Page 16
4.3
4. Place the user’s finger on the sensor again.
•
The unit sounds a short beep.
•
The fingerprint reader LED turns off.
•
The unit sounds three short beeps to indicate that the
fingerprint has been successfully enrolled.
•
If the fingerprint was not successfully enrolled, the unit sounds a
single long beep. Repeat the process from the beginning.
Programming the AYC-W6500
Programming of the AYC-W6500 is performed solely via the unit's keypad,
using a built-in Programming Menu System.
To reach the Programming Menu System, first place the AYC-W6500 into
Programming Mode. See Entering Programming Mode on page 17 for
more information.
During manufacturing, certain codes and settings are pre-programmed
into the unit. These settings are referred to here as "Default Factory
Settings".
The table below lists all the available AYC-W6500 menus.
Programming Menu
Default Factory Settings are marked by a "*" sign.
