Installation
3.
Installation
The AYC-W6500 is easy to install and fits all standard US and UK gang
boxes.
3.1
Mounting the AYC-W6500
Before connecting the AYC-W6500, mount it on an appropriate surface. In
most circumstances, the unit should be located at approximately shoulder
height.
To Mount the Unit on a Surface
1. Remove the unit's front cover, using the security spline key.
The screw holes on the back plate are now visible.
2. Select an approximate location for the unit.
3. Peel off the back of the self-adhesive installation template and
attach the template to the required location.
4. Using the template as a guide, drill four holes into the surface. The
required hole size is marked on the template.
Figure 1 AYC-W6500 Assembly and mounting
5. Drill an additional 7/16” (10mm) hole for the cable.
When installing the unit on a metallic surface, cover the inside of the
hole with a grommet or electrical tape.
6. When operating the unit as a reader, route the unit's interface cable
to the access controller.
When operating the unit as a secured controller, route the unit's
interface cable to the PS-Ax5T/TU or PS-Cx5T/TU power supply.
Rosslare recommend using a regulated linear power supply.
7. Screw the back plate into the surface. Ensure the screws are the size
specified on the installation template.
AYC-W6500 Installation Manual
Page 8
