Controller Functionality
Note:
The factory default programming code is 1234.
If a programming code is not entered within 60 seconds, the
AYC-W6500 will return to Transmit Mode.
AYC-W6500 Installation Manual
Page 37
Exiting Progra
1. To e th
•
Th
tus LED turns red
.
o Normal Access Mode.
Chan
g
The Lock T
intended for use during the initial installation of the unit.
e default Test Code is
Enter th
est
System ret
mming Mode
xit e Programming Mode at any time press the “#” key twice.
e unit sounds three short beeps.
•
The Reader sta
•
The AYC-W6500 has now returned t
gin the Lock Test Code (Testcod
e1)
est Code is an override code that opens the Lock output. It is
When the first user is enrolled into the controller, th
automatically deleted. If the code is programmed again, it will not be
deleted with the entry of additional user codes.
After the first user is enrolled and the default test code is automatically
deleted, the original (default) Test Code can not be re-programmed.
To Change the Lock Test Code (Testcode1):
Enter Programming mode (see Entering Programming Mode, page 36).
•
The Reader status LED turns orange
.
Press “1” to enter Menu 1.
1
•
The Reader status LED turns green
.
e n
e you w
Code.
ew cod
ish to set as the Lock T
urns to Normal Access Mode.
•
The unit sounds three beeps.
Notes:
•
The Lock Test Code does not operate work in Secure
Mode.
•
Wrong entries ret
urn the controller to Normal Mode.
•
Code 0000 erases the Test Code.
•
The Default Test Code is 2580.
Auxiliary Open Code Settings (Testcode2)
The Auxiliary Open Code activates the auxiliary output. This allows users to
test the unit during initial install, or after modifications.
