Controller Functionality
•
“2
Auxiliary
•
The un
s and the AYC-W6500 returns to
Normal Access Mode.
e this command to reset all codes to their factory settings and to
length.
” Open
“3” Open Lock and Auxiliary
it sounds three short beep
5.
PIN Code Length / Factory Default Settings
Us
specify a new PIN code
Warning:
Use this function with extreme care!
This function erases the unit's memory ent
irely and resets all
codes to their factory default settings.
To Set PIN Code Length and Reset to Factory Default Settings:
g Mode,
page
2. Select
00 Re
05 - Returns to factory defau
s a 5 digit code.
06 - Re
faults and se a 6 digit code.
.
1. Enter
Programming
Mode
(see
Entering Programmin
36).
the desired PIN code length as follows:
-
turns to factory defaults and sets a code.
turns to factory de
ts
lts and set
08 - Returns to factory defaults and sets a 4-8 digit code
Note:
When choosing the 4-8 digit option, you can either enter zeros
before the code, or press pound at the end
(for example if
AYC-W6500 Installation Manual
Page 59
code is
, enter either
or
5#).
ashes green
.
is invalid you will hear a long beep and
ormal Access Mode without erasing the
12345
00012345
1234
•
The Reader status LED fl
3.
Enter your programming code
.
•
If the programming code is valid, all
memory is erased. The unit sounds three beeps and the
controller returns to Normal Access Mode.
If the programming code
the controller returns to N
memory of the controller.
Note:
The programming code cannot be deleted. For example,
0000 is invalid an
d will not delete the programming code.
