Controller Functionality
3.
Changing the Modes of Operation
The unit can be easily toggled between Normal and Secure
Modes, directly from the keypad.
Changing from Normal Mode to Secure Mode
The default factory setting for the Normal/Secure code is 3838.
1. Enter the Normal / Secure code.
•
Reader status LED flashes green
.
2. Press the “#”to confirm the mode change.
•
Reader status LED flashes red
.
Changing from Secure Mode to Normal Mode
The default factory setting for Normal / Secure code is 3838.
1. Enter the Normal/Secure code.
•
Reader status LED flashes green
.
2. Press the “#” key to confirm the mode change.
•
Reader status LED turns red
.
AYC-W6500 Installation Manual
Page 33
5.3
•
Enrolling a Fingerprint
Users must complete a one-time procedure to enroll their fingerprints.
To Enroll Fingerprints in Normal Mode:
1. Present an enrolled proximity card or PIN code.
•
The fingerprint reader LED flashes orange
.
2. Place the user’s finger on the sensor.
•
The unit sounds a short beep followed by an additional three
short beeps.
The fingerprint reader LED flashes red
.
3. Place the user’s finger on the sensor again.
•
The unit sounds a short beep.
•
The fingerprint reader LED turns off.
