Ross Synergy 1, Maintenance Manual

Page: 84 / 240

4–14 • Option Boards Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
8. Insert and tighten the 2 screws, taking care not to over tighten them. Refer to the
following diagram:
Fan Assembly Synergy 1 Frame
9. When complete, carefully replace the Synergy 1 Frame Processor Board into the
frame, and secure with the outer latches on the board edges.
This completes the procedure for installing the Squeeze & Tease 3D/WARP Fan Assembly on the
Squeeze & Tease 3D/WARP card within the Synergy 1 frame. Please contact Ross Video Technical
Support if any further assistance is required. Next you will upgrade the Squeeze & Tease software.
Squeeze & Tease Software Upgrade
The Squeeze & Tease 3D/WARP board has its own CPU and, therefore, requires its own software.
The Squeeze & Tease 3D/WARP board will come preloaded with the latest version of software from
Important If you have purchased the Squeeze & Tease 3D/WARP option, you
must upgrade the software on the Squeeze & Tease 3D/WARP Board
as well.
Note
Remember to upgrade your switcher software to the same version as
the
Squeeze & Tease 3D/WARP software before you begin. The
switcher software must be upgraded before attempting to upgrade
Squeeze & Tease 3D .
Version 11 software requires the 3D fan assembly be in place before
you upgrade. Refer to the section “
Installing the 3D Fan Assembly ”
on page 4–12 for details. If you do not have the 3D Fan Assembly ,
please call Ross Video Technical Support.
3/8’’ Screws
Hex Standoffs
(Thread into mounting
holes MP1 and MP2)
Cable Assembly