Ross Synergy 1, Maintenance Manual

Page: 125 / 240

Synergy 1 and Synergy 100 Maintenance Guide (v16-S1) DVE Send Option • 7–3
4. Install Deserializer Modules (4000A-061) in each socket as follows:
• Carefully align the Deserializer Module over the socket.
• Ensure that the board’s components are facing the rear of the Frame Processor
Board .
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the Deserializer Module
horizontally (side to side), until the module is fully seated. Avoid flexing the board
— so as not to bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins.
5. Locate the following two sockets:
•
J28
— labeled
AUX1 OUT
•
J27
— labeled
AUX2 OUT
6. Install a Serializer Modules (4000A-062) in each socket as follows:
• Carefully align the Serializer Module over the socket.
• Ensure that the board’s components are facing the rear of the Frame Processor
Board .
• Use your fingers to “feel” for the proper pin-to-socket alignment.
• While applying downward pressure, slowly rock the Serializer Module
horizontally (side to side), until the module is fully seated. Avoid flexing the board
— so as not to bend the pins.
• After installation, “sight” down the board at the connector level, to make sure that
there are no exposed pins.
7. Replace the Frame Processor (CPU) Board in the Synergy 1 frame.
8. Power on the Synergy 1 frame.
This completes the procedure to install the DVE Send Option . Next you will install the Software
Option Registration Key for the DVE Send Option .
Note The AUX1 IN and AUX2 IN signals route the video and alpha signals
of the DVE to the third (internal) keyer of the Synergy MLE — which
is reserved exclusively for
DVE Send operations.
Caution Failure to reinstall a Deserializer Module with a precise 1:1
pin-to-socket orientation will damage the Frame Processor Board ,
the selected module — or both! Double check your work!
Caution Failure to reinstall a Serializer Module with a precise 1:1
pin-to-socket orientation will damage the Frame Processor Board ,
the selected module — or both! Double check your work!