Ross Synergy 1, Maintenance Manual

Page: 28 / 240

2–4 • System Architecture Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
Synergy 1 Frame – Front View
The figure below illustrates the front of the frame, with the door removed. The layout is identical for
the Synergy 1 and Synergy 100 switchers.
Synergy 1 Frame — Front View
The following are descriptions of each front component.
1. Frame CPU Board
The Frame CPU Board provides all the electronics required for the Synergy switcher.
The board also houses several “daughter” boards for options such as Squeeze & Tease
2D or WARP , Ultimatte Insider , Aspectizer , or the Dual Border Generator .
2. Power Supply Lock Down Plate
The power supply is held in place with a single lock-down plate that is secured with two
screws. These screws must be loosened and the lock-down plate moved up in order to be
able to remote the power supply.
3. Power Supply Handle
A small handle is provided to assist in removing and inserting the power supply. The
tray houses the power supply and frame fan. For frame cooling, note that air flows in
from the sides of the frame, across the circuit boards and out the rear exhaust port.
1) Frame CPU Board
2) Power Supply Lock Down Plate
3) Power Supply Handle 4) Fan Fail LED
5) Power Fail LED
6) Power On LED 7) Power Switch
8) Fuse
Warning
Hazardous
Voltages
When the power supply is inserted into the frame, it mates with male
power pins that carry
live voltage if the frame is plugged in. All power
must be disconnected before servicing.
Caution — do not insert your fingers into the power supply slot when
the unit is plugged in!
PWR
OK
PWR
FAIL
FAN
FAIL
FUSE
T4A/250V
POWER
DIGITAL PRODUCTION SWITCHER
TO REDUCE THE RISK OF
FIRE REPLACE WITH SAME
FUSE AND RATING
CAUTION:
1 4
5 2
3
6 7 8