Ross Synergy 1, Maintenance Manual

Page: 32 / 240

2–8 • System Architecture Synergy 1 and Synergy 100 Maintenance Guide (v16-S1)
13. Peripheral 2 Ports
The
PERIPHERAL 2
group includes three ports:
• One 9-pin, D-Type RS-422/RS-232 port is provided for connection to a primary
peripheral device. The connection is for control purposes. The port can be
configured for additional serial control purposes through the menu system.
• Two BNCs labeled
Rx
and
Tx
are provided for communications with peripheral
devices such as the CDK-111A-M.
14. Output Section
Fifteen BNCs are provided as the switcher outputs, plus the digital reference input, as
follows:
• Two program outputs (
PGM1
and
PGM2
).
• Two preview outputs (
PV1
and
PV2
). Both outputs display the overlay as
controlled from the menu system.
• Ten Aux Bus outputs (
Aux1
through
Aux10
). Aux outputs 1 and 2 can be timed or
untimed , depending upon the number of Timed Aux Bus options installed. Aux
outputs 3 through 10 are untimed.
• One optional clean feed output (
CLEAN
).
• One digital reference input ( 601 REF IN ).
If DAs are required to provide additional outputs for a particular signal, contact Ross
Video or your Ross Video dealer for details.
15. Input Section
Sixteen BNCs are provided for the digital inputs of the switcher.
Note The two Peripheral 2 BNCs share the same internal circuitry as the
9-pin, D-Type, Peripheral 2 connector. Only one of the two sets of
connectors can be used at a time.
Note Since the Synergy 1 SD frame generates its own internal black signal,
selecting
BLACK on an untimed Aux Bus will route to the output
whatever is connected to your “ 601 REF IN ” BNC, with the exception
of Aux Bus 1 and 2.
Any of the 10 Aux Bus outputs can be used for the primary DVE, the
DVE that can be controlled using RS-422 serial control from the
Synergy 1 control panel
only . Refer to the section “ Output
Connection ” in the Synergy 1 Installation Guide for additional
information.
This feature is not available for the Synergy 100 control panel.