Rolando Texart XT-640, User Manual

Page: 142 / 156

140
6
FA
Q
A Message Appears
These are the main messages that appear on the machine's display to prompt correct operation.
They do not indicate any errors. Follow the prompts and take action accordingly.
[PRESS THE ENTER KEY TO CONTINUE OPERATION]
If the front cover, left cover, or right cover (hereafter collectively referred to as “covers”) is opened during printing
or any other operation where the print-head carriage is moving, the printer will perform an emergency stop.

P. 142 "[CLOSE COVER (FRONT COVER/COVER L/COVER R)]"
When an emergency stop occurs, a message requesting the covers be closed will be displayed on the screen.
Close the covers as directed in the instructions shown on the screen. After closing the covers, the above
message appears on the screen. Press
as directed in the instructions shown on the screen. Once
recovery from the error is complete, you will be able to continue working.
If the message requesting the front cover be closed does not disappear even after you close the front cover,
the media may be in contact with the front cover, which will prevent the front cover from closing. In this
situation, try the following methods.

Close the front cover while holding down the end of the media.

Pull the media to the front until it is in a position where its end is not in contact with the front cover, and
then close the front cover.

Cut the end of the media so that it is not in contact with the front cover, and then close the front cover.
If the media is still in contact with the front cover even after you try these methods, change the media.
[1

2

3

4

5

6

7

8

]
Ink has run out. Replace the ink pouch indicated by the flashing number with a new pouch.
[PRESS THE POWER KEY TO CLEAN]
This message appears when the machine has been unused for about one month. Switch on the sub power
once a month.

P. 91 "When Not in Use for a Prolonged Period"
[SHEET NOT LOADED SETUP SHEET]
Load the media. This message appears when an attempt to perform a printing test was made while no media
was loaded.
[END OF THE SHEET]
The trailing edge of the media was detected during operation. Press any key on the operation panel to clear
the message. Load new media.
[CHECK DRAIN BOTTLE]
This appears when a certain amount of discharged fluid collects in the drain bottle. To clear the message, press
. If this screen appears, go to the [DRAIN BOTTLE] menu and discard the discharged fluid in the bottle.

P. 63 "Disposing of Discharged Fluid"
[INSTALL DRAIN BOTTLE]
Check whether the drain bottle is installed. Install the drain bottle, then press .

P. 63 "Disposing of Discharged Fluid"