Rolando Texart XT-640, User Manual

Page: 135 / 156

133
6
FA
Q
Media Feed Is Not Smooth
A variety of problems can occur if the media feed is not smooth. This can cause such problems
as poor printing results, contact with the media by the print heads, misaligned positioning, or
media jams. Take action as follows.
Media Wrinkles or Shrinks
Are the media clamps attached?
When you are performing printing, be sure to attach the media clamps.
Is the media loaded straight and securely?
Feed is not smooth when the media is not straight or is tensioned unevenly on the left and right. Reload the
media.

P. 21 "Loading Media"
Was loaded media allowed to stand for some time?
Media may shrink or wrinkle if it is heated for an extended time. When printing ends, switch off the sub power
or remove the media. Store removed media in a suitable environment.

P. 19 "Media Storage Environment"
Is the media sagging?
If sagging media is used, it may come out wrinkled.
Is the temperature of the dryer too high?
Set the temperature to suitable values for the type of media.

P. 97 "Using the Dryer"
Is the temperature of the room too low?
Use the machine in an environment with an ambient temperature of 18 to 25°C (64 to 77°F). If the machine is
used at an ambient temperature of less than 18°C (64°F), then depending on the type or width of the media,
wrinkling or temperature-caused unevenness may occur. To obtain stable printing results, use the machine
in an environment with an ambient temperature of 18 to 25°C (64 to 77°F).
Is the humidity of the room too high?
Use the machine in an environment of 35 to 65% RH (no condensation).