Rolando Texart XT-640, User Manual

Page: 99 / 156

97
4
Advanced Functions
Using the Dryer
What is the Dryer?
This machine is equipped with a dryer for drying the ink. You can adjust the temperature settings to match
the type of media and the printing speed.
WARNING
Caution: High temperatures
The dryer becomes hot. Exercise caution to avoid fire or burns.
WARNING
Remove any loaded media or switch off the sub power when printing is
not being performed.
The continued application of heat at a single location may cause fire or produce
toxic gases.
WARNING
Never use media that cannot withstand the heat.
Doing so may result in fire or the release of toxic gases or may degrade the
media.
WARNING
Never use the platen or dryer for any purpose for which they are not
intended, such as to dry clothing.
Doing so may cause overheating, resulting in a fire or accident.
Use the machine in an environment with an ambient temperature of 20 to 32°C (68 to 90°F).
If the machine is used at an ambient temperature lower than 20°C (68°F), then depending on the type or
width of the media, wrinkling or temperature-caused unevenness may occur. If this happens, try lowering
the temperature of the dryer by about 2°C (36°F). To obtain stable printing results, however, use the machine
in an environment with an ambient temperature of 20 to 32°C (68 to 90°F).
Note: Depending on the printing conditions, an external heater may be needed. For the details of the rec-
ommended external heater, contact your authorized Roland DG Corp. dealer. For information on how to
use the external heater, refer to the documentation for the heater you are using.
Dryer
This is used to speed up
the drying of the ink.