Rolando Texart XT-640, User Manual

Page: 48 / 156

Setup of Media
2
Basic Operation
46

To confirm again/adjust again
Press to select [YES].
Press to confirm your entry.
The test pattern of bidirectional correction is printed again. Go back
to step

and set again.
To go to the next after correction is completed
Press to select [DONE].
Press to confirm your entry.
For the individual setting method and the description of this setting item, refer to the following section.
 P. 102
"Correcting for Misalignment in Bidirectional Printing"
6.
Set the drying method and time after printing.

Press or to select a value.
Press to confirm your entry.
For the individual setting method and the description of this setting item, refer to the following section.

P. 100
"Drying the Trailing Edge of the Printing Area on the Dryer"

Press or to set the drying time.
Press to confirm your entry.
For the individual setting method and the description of this setting item, refer to the following section.
 P. 101
"Setting the Drying Time after Printing"
REDO ADJ.?
[YES] DONE
FEED FOR DRY
DISABLE ENABLE
Drying method after printing
Set whether the media should be fed until the trailing edge of the printed area is put on the dryer
after the 1st page is printed. To make sure to dry the entire printed area, select "ENABLE". If "DISABLE"
is selected, the trailing edge of the printing area is not fed to the dryer unless you continue with a
subsequent printing operation.
DRYING TIME
10min 10min
Example of setting time (general guide)
Note: The setting time varies according to the settings such as the
type of media and the printing quality.
Condition: Non-coated vinyl chloride media
Setting time: About three minutes
Drying time after printing
Set the drying time after the 1st page is printed. The next operation is not started until the set time
passes.
Current setting Setting after
change