Getting started
R&S
®
LCX Series
29
User Manual 1179.2260.02 ─ 02
Table 4-6: Navigation controls
Key
Assigned functions
[Auto]
Activates the automatic selection of the measurement function.
[Hold]
Freezes the measurement range, on the screen indicated with prefix "Hold:"
at the range value.
[Trig.]
Triggers a measurement manually.
POWER On/Standby key
The [On/Standby] key switches the instrument from the standby to the ready state or
vice versa.
The [On/Standby] lights green when the instrument is switched on, see
4.2.1.3
Connectors
The measurement input connectors and the USB connector are on the
.
L CUR, L POT, H CUR, H POT
Four BNC sockets:
●
"L CUR" (low current): signal output for series measurements (signal generator).
●
"L POT" (low potential): signal input for parallel measurement (voltage measure-
ments).
●
"H CUR" (high current): signal input for series measurements (current measure-
ments).
●
"H POT" (high potential): signal input and output for parallel measurements (mea-
surement bridge).
Ground socket
Protective ground socket (4
mm banana socket) to secure the R&S
LCX, e.g. with a
grounded external conductor.
The front panel ground socket is directly connected to the mains safety ground by the
line cord.
USB A
Female USB (universal serial bus) connector of type A (host USB). You can connect a
USB memory stick, e.g., to record and export measurement data, to capture screen-
shots, or to update the firmware.
Chapter 4.1, "Preparing for use"
4.2.2
Rear panel tour
This section provides an overview of the connectors at the rear panel of the instrument.
For technical data of the connectors, see the data sheet.
Instrument tour
www.allice.de
Allice Messtechnik GmbH
