Rohde & Schwarz NRP T Series, User Manual

Page: 80 / 169

Remote Control Commands
R&S
®
NRPxxT(N)
80 User Manual 1177.6023.02 ─ 08
If you enter a value without unit, the unit is defined by
TRIGger:LEVel:UNIT
.
If an S-parameter device is active and/or if a mounted component with a global offset
in front of the sensor is considered, the currently effective trigger threshold and a trig-
ger threshold to be input are referenced to the appropriately shifted sensor data. If the
S-parameter device and/or the offset correction are disabled, the trigger threshold and
its input limits are adjusted as necessary.
Parameters:
<level> Range: 300e-9 to 100.0e-3
*RST: 3.0e-5
Default unit: Watts
Manual operation: See "Trigger Level" on page 51
TRIGger:LEVel:UNIT <unit>
Sets the unit of the trigger level if this value is entered without a unit.
See also
TRIGger:LEVel
on page 79.
Parameters:
<unit> DBM | W | DBUV
*RST:
W
Manual operation: See "Trigger Level" on page 51
TRIGger:SENDer:PORT <sender_port>
Selects the port where the sensor outputs its own trigger event in case it is trigger
sender. See
TRIGger:SENDer:STATe
for more information.
If the sensor is the trigger sender, it can output its trigger event either on the
EXTernal<1>
or
EXTernal2
.
If the sensor triggers itself, the trigger source of the sensor must be assigned to the
other external port, as shown in the examples.
Parameters:
<sender_port> EXT1 | EXTernal1 | EXT2 | EXTernal2
*RST:
EXT1
Example: TRIG:SEND:PORT EXT1
TRIG:SOUR EXT2
TRIG:SEND:STAT ON
Example: TRIG:SEND:PORT EXT2
TRIG:SOUR EXT1
TRIG:SEND:STAT ON
Controlling the Measurement