Rohde & Schwarz NRP T Series, User Manual

Page: 48 / 169

Browser-Based User Interface
R&S
®
NRPxxT(N)
48 User Manual 1177.6023.02 ─ 08
● Sensor Settings .......................................................................................................48
● Averaging Settings .................................................................................................. 49
● Trigger Settings .......................................................................................................50
● System Settings ...................................................................................................... 52
6.5.1 Sensor Settings
Describes the parameters for optimizing the measurement results for specific measure-
ment requirements.
Further information:
●
Chapter 9.8.3, "Configuring Corrections" , on page 92
●
Chapter 9.9, "Calibrating, Zeroing" , on page 108
●
Chapter 9.10, "Testing" , on page 111
Access: main dialog of the web user interface > navigation pane > "Sensor"
Γ Correction ...................................................................................................................48
└ <State> ........................................................................................................... 48
└ Magnitude ....................................................................................................... 48
└ Phase ..............................................................................................................48
Zero Calibration .............................................................................................................49
Sensor Information ........................................................................................................49
Γ Correction
Groups the parameters for the complex reflection coefficient. See also Chapter 9.8.3.4,
"S-Gamma Corrections" , on page 96.
<State> ← Γ Correction
Enables or disables the use of the complex reflection coefficient of the signal source,
Γ
source
.
Remote command:
[SENSe<Sensor>:]SGAMma:CORRection:STATe
Magnitude ← Γ Correction
Sets the magnitude of the complex reflection coefficient of the source ,
Γ
source
.
A value of 0.0 corresponds to an ideal matched source. A value of 1.0 corresponds to
total reflection.
Remote command:
[SENSe<Sensor>:]SGAMma:MAGNitude
Phase ← Γ Correction
Sets the phase angle of the complex reflection coefficient of the source,
Γ
source
.
Settings