Rohde & Schwarz NRP T Series, User Manual

Page: 81 / 169

Remote Control Commands
R&S
®
NRPxxT(N)
81 User Manual 1177.6023.02 ─ 08
TRIGger:SENDer:STATe <state>
Enables or disables the trigger sender mode of the sensor. In this state, the power sen-
sor can output a digital trigger signal in sync with its own trigger event.
If enabled, select the output port for the trigger signal using
TRIGger:SENDer:PORT
.
Typically, the trigger sender uses its internal trigger source. But you can also trigger the
trigger sender externally, because the power sensor has got two external trigger con-
nectors. If you trigger the trigger sender externally, use
EXTernal1
as external trigger
input port (trigger source) and
EXTernal2
as trigger sender output port or vice versa.
Parameters:
<state> *RST: OFF
TRIGger:SLOPe <slope>
Effective only if
TRIGger:SOURce
is set to
INTernal
or
EXTernal
.
Determines which edge of the envelope power, with internal triggering, or increasing
voltage, with external triggering, is used for triggering.
Parameters:
<slope> POSitive | NEGative
POSitive
Rising edge
NEGative
Falling edge
*RST:
POSitive
Manual operation: See "<Slope>" on page 51
TRIGger:SOURce <source>
Selects the source for the trigger event detector.
Parameters:
<source> HOLD | IMMediate | INTernal | BUS | EXTernal | EXT1 |
EXTernal1 | EXT2 | EXTernal2
See
Chapter 9.5.2.3, "Trigger Sources" , on page 71.
*RST: IMMediate
Manual operation: See "<Source>" on page 50
TRIGger:SYNC:PORT <sync_port>
Selects the external connection for the sync output of the sensor. For more information,
see
TRIGger:SYNC:STATe
.
Controlling the Measurement