Rohde & Schwarz NRP T Series, User Manual

Page: 46 / 169

Browser-Based User Interface
R&S
®
NRPxxT(N)
46 User Manual 1177.6023.02 ─ 08
<Value> ← Offset
Adds a fixed level offset in dB to account for external losses.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet
S-Parameter
Selects the mode used for the S-parameters. S-parameters are used to compensate
for a component (attenuator, directional coupler) connected ahead of the sensor. See
also
Chapter 9.8.3.3, "S-Parameter Correction" , on page 94.
Averaging
Groups the averaging settings. See also Chapter 9.8.1, "Configuring Auto Averaging" ,
on page 88.
<Mode> ← Averaging
Sets the averaging mode.
"Manual" Disables auto averaging. Enter the average count under "<Value>"
on page 46.
"Auto 1 dB" / "Auto 0.1 dB" / "Auto 0.01 dB" / "Auto 0.001 dB"
Uses an automatic averaging filter with the respective resolution
index.
Predefines the compliance to an exactly defined noise component.
Enter this value under
"<Value>" on page 46.
Remote command:
[SENSe<Sensor>:]AVERage[:STATe]
[SENSe<Sensor>:]AVERage:COUNt:AUTO
[SENSe<Sensor>:]AVERage:COUNt:AUTO:TYPE
<Value> ← Averaging
The content of this field depends on the setting under "<Mode>" on page 46.
●
If "Manual" is set:
Sets the average count, also called averaging factor.
●
If "Auto xx dB" is set:
Displays the resolution index.
●
If "Noise Content" is set:
Sets the maximum noise ratio in the measurement result.
Remote command:
[SENSe<Sensor>:]AVERage:COUNt
[SENSe<Sensor>:]AVERage:COUNt:AUTO:RESolution
[SENSe<Sensor>:]AVERage:COUNt:AUTO:NSRatio
6.4 Measurement Modes
Describes the parameters for the available measurement modes.
● Continuous Average Mode ......................................................................................47
Measurement Modes