Rohde & Schwarz NRP T Series, User Manual

Page: 52 / 169

Browser-Based User Interface
R&S
®
NRPxxT(N)
52 User Manual 1177.6023.02 ─ 08
6.5.4 System Settings
Describes the parameters of the general network environment and specific identifica-
tion parameters of the power sensor in the network.
Further information:
●
Chapter 9.11, "Configuring the System" , on page 111
Access: main dialog of the web user interface > navigation pane > "System"
IP Address .....................................................................................................................52
Subnet Mask ................................................................................................................. 52
Sensor Name ................................................................................................................ 52
Gateway ........................................................................................................................ 52
DHCP ............................................................................................................................ 53
Selftest .......................................................................................................................... 53
Apply Network Settings ................................................................................................. 54
Firmware Update ...........................................................................................................54
IP Address
Sets the IP address of the sensor.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress
Subnet Mask
Sets the subnet mask.
The subnet mask consists of four number blocks separated by dots. Every block con-
tains 3 numbers in maximum.
Remote command:
SYSTem:COMMunicate:NETWork:IPADdress:SUBNet:MASK
Sensor Name
Sets the sensor name. The sensor name is displayed in the title bar of the web user
interface, see
Figure 6-1 .
If you do not specify a sensor name, the hostname is used as default. See also
SYSTem:COMMunicate:NETWork[:COMMon]:HOSTname
on page 113.
Remote command:
SYSTem[:SENSor]:NAME
Gateway
Sets the address of the default gateway, that means the router that is used to forward
traffic to destinations beyond the local network. This router is on the same network as
the instrument.
Settings