Rohde & Schwarz NRP T Series, User Manual

Page: 26 / 169

Power Sensor Tour
R&S
®
NRPxxT(N)
26 User Manual 1177.6023.02 ─ 08
Table 4-1: R&S NRPxxT(N) RF connector characteristics
Power sensor Male connector Matching female con-
nector Tightening torque
R&S NRP18T
N N 1.36 Nm (12'' lbs)
R&S NRP18TN
R&S NRP33T
3.50 mm
3.50 mm/ 2.92 mm/ SMA
0.90 Nm (8'' lbs)
R&S NRP33TN
R&S NRP40T
2.92 mm
R&S NRP40TN
R&S NRP50T
2.4 mm
2.4 mm/ 1.85 mm
R&S NRP50TN
R&S NRP67T
1.85 mm
R&S NRP67TN
R&S NRP90T
1.35 mm 1.35 mm
R&S NRP90TN
R&S NRP110T 1.0 mm 1.0 mm 0.23 Nm (2'' lbs)
4.2 Trigger I/O Connector
The trigger I/O is a connector of SMB type.
It is used as an input for signals if the trigger source parameter is set to
EXTernal2
. It
is used as an output for trigger signals if the sensor is operated in the trigger sender
mode.
Further information:
●
Chapter 9.5.2, "Triggering" , on page 70
4.3 Host Interface
The host interface is used for establishing a connection between the power sensor and
a USB host. For this purpose, an external cable is needed. See
Chapter 3.5, "Connect-
ing a Cable to the Host Interface" , on page 14.
4.4 Status LED
The status LED gives information about the state of the power sensor. The following
states are defined:
Status LED