Rohde & Schwarz NRP T Series, User Manual

Page: 45 / 169

Browser-Based User Interface
R&S
®
NRPxxT(N)
45 User Manual 1177.6023.02 ─ 08
dBm or dBµV. To change the unit, you must specify the desired value together with the
full new unit once.
Example:
To change the representation of a "Trigger Level" of 100
µ
W into dBm, enter -10dbm in
the "Trigger Level" field. All future entries of solely numbers represent the value in
dBm. If you enter
-15 in the field, the "Trigger Level" value is set to -15.00 dBm.
If you want to revert the value to watt, enter 50uW . The "Trigger Level" value is set a
value of 50.00
µ
W, thus changing the unit for the further numeric entries.
6.3 Common Settings
Describes the common sensor settings that are available for all measurement modes.
Access: main dialog of the web user interface > top pane
Measurement ................................................................................................................ 45
Frequency ..................................................................................................................... 45
Offset .............................................................................................................................45
└ <State> ........................................................................................................... 45
└ <Value> ...........................................................................................................46
S-Parameter ..................................................................................................................46
Averaging ...................................................................................................................... 46
└ <Mode> ...........................................................................................................46
└ <Value> ...........................................................................................................46
Measurement
Enables or disables the measurement.
Remote command:
INITiate:CONTinuous
Frequency
Sets the carrier frequency of the applied signal. This value is used for frequency-
response correction of the measurement result.
Remote command:
[SENSe<Sensor>:]FREQuency
Offset
Groups the offset settings.
<State> ← Offset
Enables or disables the usage of the level offset.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet:STATe
Common Settings