Rockwell Automation iTRAK, User Manual

Page: 95 / 124

Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019 95
Maintenance Chapter 5
4. Maintain push force on apex and apply the straight-to-straight rail
alignment clamp to the curve to straight joints.
5. Apply Loctite 243 to the M5 x 0.8 x 20 mm LHCS rail screws, as
required.
6. Install the M5 x 20 mm low head socket cap screws and torque to 9 N•m
(6.6 lb•ft).
Start at the apex and work toward the rail ends and alternate sides.
7. Tighten the two straight rail M5 x 20 mm low head socket cap screws
and torque to 9 N•m (6.6 lb•ft).
8. Release push force and clamp tools.
Install a Top or Bottom Radial Curved Rail
Use this procedure to install a top or bottom radial curved rail.
Before You Begin
Install top or bottom straight rails before you install the radial curved rails.
What You Need
• M5 x 0.8 x 20 mm low head socket cap screw (X12)
• A radial curved rail segment
• 4 mm hex driver
• Loctite 243
• The straight-to-curved rail alignment clamp, from the 2198T-A04
iTRAK TriMax rail aligning tool kit
To install a top or bottom radial curved rail, complete these steps.
1. Loosen the two straight rail end screws that are next to curve.
2. Place radial curved rail in position.
ATTENTION: Before attempting any service to an iTRAK system. See Safety
Information on page 28 .