Rockwell Automation iTRAK, User Manual

Page: 88 / 124

88 Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019
Chapter 5 Maintenance
Figure 29 - Straightening Bar Configurations
What You Need
• M5 x 0.8 x 20 mm low head socket cap screws, as required
• A straight rail segment
• 3 mm, 4 mm, and 5 mm hex drivers
• Loctite 243
• 2198T-A06 iTRAK TriMax rail straightening tool
To install a top or bottom rail complete these steps.
1. Choose the rail configuration that you would like to install from
Figure 29 .
2. Apply Loctite 243 to the M5 x 0.8 x 20 mm LHCS rail screws, as
required.
3. Place straight rail loosely into position.
4. Lightly install rail screws, do not tighten.
The track top plate is not shown for clarity.
Shoulder Screw Shoulder Screw
The straightening bar tool holes corresponded to the motor module shoulder-screw holes.
Shoulder screws that are shown here are for three motor module configuration.
Three Motor Module
Configuration
Two Motor Module
Configuration
Single Motor Module
Configuration