Rockwell Automation iTRAK, User Manual

Page: 41 / 124

Rockwell Automation Publication 2198T-UM002C-EN-P - March 2019 41
Track Installation Chapter 2
Install the Lubrication
System The iTRAK lubrication system, catalog number 2198T-AL-SYS, comes with a
coil of tube to connect system fittings to the remotely located pumps and
system fittings. Three pump assemblies are included in the system; one is
intended for each bearing rail. The assembled pumps have push-to-connect
connectors with plugs. These plugs help prevent oil from leaking during
shipment. You remove these plugs when you are ready to connect the tubes.
The pump fittings contain a check valve to help prevent backflow when a
replacement reservoir is installed.
The lubrication system is assembled with right angle fittings. Additional
straight hex nipple fittings are provided to let you redirect pump tubing. If
your system requires straight exit from the pump, use the supplied straight
fittings to replace the right angle fittings. Use Teflon tape for the tapered NPT
threads.
The reservoir uses a straight 1/4 BSPP thread. A sealing washer is supplied.
Figure 17 - Lubrication Pump Description
1
2
3
4
5
6
7
8
9
10
11
12
Item Description Item Description
1 5 m (16.4 ft) Digital signal cable 7 Brass elbow fitting
2 Digitally activated pump 8 Straight brass fitting
(1)
(1) If your installation requires the tubing to exit the pumps vertically, you can replace the brass elbows with the two
straight brass nipples that are supplied with the kit.
3 Pump status indicators 9 Mounting bracket
4 Lubricant cartridge 10 0.25-20 x 0.5 screw
5 Plug 11 Beam clamp
6 Check valve 12 0.25-20 x 1.25 screw