Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 24 / 224

1-10 Installation/Wiring
Publication 9VT-UM001D-EN-P
Moving the “Line Type” jumper shown in Figure 1.5 will allow single or
three-phase operation.
Important: When selecting single-phase operation, input power must
be applied to the R (L1) and S (L2) terminals only.
Selecting/Verifying Fan Voltage (Frames 5 & 6 Only)
Important: Read Attention statement above!
Frames 5 & 6 utilize a transformer to match the input line voltage to the
internal fan voltage. If your line voltage is different than the voltage class
specified on the drive nameplate, it may be necessary to change
transformer taps as shown below. Common Bus (DC input) drives
require user supplied 120 or 240V AC to power the cooling fans. The
power source is connected between “0 VAC” and the terminal
corresponding to your source voltage (see
Figure 1.11 ).
Table A Fan VA ratings (DC Input Only)
Figure 1.5 Typical Locations - Phase Select Jumper & Transformer (Frame 5 shown)
Frame 6 Transformer Tap Access
The transformer is located behind the Power Terminal Block in the area
shown in
Figure 1.5 . Access is gained by releasing the terminal block
from the rail. To release terminal block and change tap:
1. Locate the small metal tab at the bottom of the end block.
2. Press the tab in and pull the top of the block out. Repeat for next
block if desired.
3. Select appropriate transformer tap.
4. Replace block(s) in reverse order.
Frame Rating (120V or 240V)
5
100 VA
6 138 VA
LI N E
TYPE
S P AR E 1
S P AR E 2
3-PH 1-PH
480 Volt Tap
600 Volt Tap
690 Volt Tap
400 Volt Tap
Fan Voltage
Phase Selection
Jumper
W I R E RAN GE: 14-1/0 AW G (2.5-35 MM 2)
TO R QUE: 32 I N -LB (3.6 N - M )
S T R IP LE N GTH: 0.67 I N (17 MM )
U S E 75
°
C CU W I R E O N LY
PO W E R TE RM I NA L RA TI N G S
W I R E RAN GE: 6-1/0 AW G (16-35 MM 2)
TO R QUE: 44 I N -LB (5 N - M )
S T R IP LE N GTH: 0.83 I N (21 MM )
G R OU N D TE RM I NA L RA TI N G S (PE)
300 VDC EXT P WR S PLY TE RM (P S +, P S -)
W I R E RAN GE: 22-10 AW G (0.5-4 MM 2)
TO R QUE: 5.3 I N -LB (0.6 N - M )
S T R IP LE N GTH: 0.35 I N (9 MM )
17
21
I N PUT A C OUTPUT
Optional
Communications
M odule
9