Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 208 / 224

C-12 Application Notes
Publication 9VT-UM001D-EN-P
Figure C.5 Sleep Wake Mode
Is S leep- W ake
W orking?
Have these conditions been met?
Is R equired Input Closed?
( S top, Enable, R un)
Did a Drive
Fault Occur?
W hich R equired Input
was Chosen?
M eet all Conditions!
Close Input
R eset Fault
Yes
Yes
S top or Enable
R un, R un Forward
or R un R everse
Yes
Yes
Drive R unning?
N o
N o
N o
N o
N o
N o
Issue a S tart Command
(OI M , N etwork or TB)
Open & Close Input
Consult Factory
N o
Consult Factory
1. 179 [ S leep- W ake R ef] must be set to the analog input that will control
" S tart/ S top" functions.
2. 178 [ S leep- W ake M ode] must = "1, Direct" (Enable).
3. 182 [ S leep Level] must be less than 180 [ W ake Level] in Direct mode).
4. 90 [ S peed R ef A S el] must be set to a speed reference source that will
control the drive. If 179 [ S leep- W ake R ef] = 90 [ S peed R ef A S el], the
same analog signal will control start/stop and speed reference.
5. A t least one of the following must be programmed for 361-366 [Digital
Inx S el]: " N ot S top," "Enable," " S tart," " R un," " R un Forward," " R un
R everse."
Is A nalog S ignal Greater
than or equal to 180 [ W ake Level]?
and for time period greater than or
equal to 181 [ W ake Time]
Yes
Increase A nalog Input
S ignal and wait for a time
period greater than or
equal to 181 [ W ake Time].
W as a S top Issued?
or Power Cycled?