Rockwell Automation 9VT201-007HTNNN, User Manual, Page: 138 / 224

4-8 Troubleshooting
Publication 9VT-UM001D-EN-P
Table 4.B Fault Cross Reference
An alarm is a condition that, if left untreated, may stop the drive. There
are two alarm types.
The drive indicates alarm conditions in the following ways:
•
Ready LED on the drive cover (see Status Indicators on page 2-3 ).
•
Alarm name and bell graphic on the LCD OIM (see Appendix B ).
The alarm is displayed as long as the condition exists. The drive
automatically clears the alarm when the condition causing it is
removed.
•
Status parameters 211 [Drive Alarm 1] and 212 [Drive Alarm 2]
indicate the status of type 1 and type 2 alarms, respectively. Refer to
Chapter 3 for the parameter descriptions.
No.
(1)
Fault No.
(1)
Fault No.
(1)
Fault
2 Function Loss 38 Phase U to Grnd 80 AutoTune Aborted
3 Power Loss 39 Phase V to Grnd 81-86 Port 1-6 DPI Loss
4 UnderVoltage 40 Phase W to Grnd 100 Parameter Chksum
5 OverVoltage 41 Phase UV Short 101 UserSet1 Chksum
7 Motor Overload 42 Phase UW Short 102 UserSet2 Chksum
8 Heatsink OvrTemp 43 Phase VW Short 103 UserSet3 Chksum
9 Trnsistr OvrTemp 48 Params Defaulted 104 Pwr Brd Chksum1
12 HW OverCurrent 63 Shear Pin 105 Pwr Brd Chksum2
13 Ground Fault 64 Drive Overload 106 Incompat MCB-PB
24 Decel Inhibit 69 DB Resistance 107 Replaced MCB-PB
25 OverSpeed Limit 70 Power Unit 108 Anlg Cal Chksum
29 Analog In Loss 71-76 Port 1-6 Net Loss 120 I/O Board Mismatch
33 Auto Rstrt Tries 77 IR Volts Range 121 I/O Comm Loss
36 SW OverCurrent 78 FluxAmpsRef Rang 122 I/O Board Fail
37 Phase Imbalance 79 Excessive Load
(1)
Fault numbers not listed are reserved for future use.
Drive Alarms
Type Alarm Description
➀
User Configurable These alarms can be enabled or disabled by 259 [Alarm
Config 1].
The status of these alarms is shown in 211 [Drive Alarm 1].
➁
Non-Configurable These alarms are always enabled.
The status of these alarms is shown in 212 [Drive Alarm 2].