Ricoh Lanier AP206, Setup Manual

Page: 30 / 406

Installing Options
18
2
E
Insert the printer board into the
printer. Fasten both screws.
F
Connect all cables removed in
step
A
.
G
Plug the printer's power cord
back into the printer and the out-
let. Turn on the printer's power
switch.
H
Print a configuration page to con-
firm that the network interface
board is properly installed.
Reference
⇒
"Printing the Configuration
Page" in the "Printer Reference"
included as a PDF file on the
CD-ROM
Note
❒
If the network interface board is
not properly installed, follow
the above procedure to reinstall
it. If you fail again, contact your
sales or service representative.
Connecting the Printer to the
Network
Follow these steps to connect the
printer to the network.
A
Confirm that you have the correct
network cable.
B
Confirm that the printer's power
switch is turned off. If it is on,
turn it off.
C
Loop the network cable. The loop
should be about 15 cm (6 inch)
from the end of the cable on the
end closest to the connector.
D
Attach the ferrite core to the loop.
E
Attach the network cable to the
10BASE-T/100BASE-TX port of
the printer.
F
Connect the other end of the cable
into the network.
ZDGP040J
TFWX980E
ZDGP050J