
PRINTER ENGINE SERVICE MODE
17 January, 2003
5-56
5
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
7 Result
*BCU Displays the result of the latest line position
adjustment in 4 digits.
First and second digits: Error detected on the rear
ID sensor
Third and fourth digits: Error detected on the
center ID sensor
Fifth and sixth digits:
Error detected on the
front ID sensor
<Result>
0 1 0 1 0 1
The 6th digit
↑
↑
The 1st digit
Refer to the Troubleshooting section for more
details about the two-digit codes.
8 Exe. Counter
*BCU Displays how many times the line position
adjustment has been executed.
Counts up by +1 normally.
After a forced adjustment and a PCU replacement,
it counts up +3
Also includes adjustments done at the factory.
9 Error Counter
*BCU Displays how many times errors have been
detected during the line position adjustment.
The way that the auto line position adjustment is done can be adjusted using the following
SP modes (SP5-993-010 to 021). These are coefficients used for the adjustment.
Normally, do not change except if the automatic adjustment gives poor results immediately
after installing a new optics housing unit. Change the value then do a forced line position
adjustment (SP 5-993-2) to check the effects of the changes.
Example: If magenta is always shifted one dot to the left, reduce 5-993-11 by 1.
10 M Reg. [Y]
*BCU
11 M Reg. [M]
*BCU
12 M Reg. [C]
*BCU
A fine adjustment to the main-scan registration.
[ -128 to 127 / 0 / 1 dot/step ]
FA
1 dot = 20
µ
13 M Mag. [Y]
*BCU
14 M Mag. [M]
*BCU
15 M Mag. [C]
*BCU
A fine adjustment to the main-scan magnification.
[ -100 to 100 / 0 / 0.01 %/step ]
FA
NOTE:
The setting changes in this SP mode will
be affect the next line position adjustment.
16 S Reg. 600[Y]
*BCU
17 S Reg. 600[M]
*BCU
18 S Reg. 600[C]
*BCU
19 S Reg. 1200[Y]
*BCU
20 S Reg. 1200[M]
*BCU
993
21 S Reg. 1200[C]
*BCU
A fine adjustment to the sub-scan registration for
each color (color registration).
[ -128 to 127 / 0 / 1 dot/step ] FA
600dpi: 1 dot = 40
µ
1200 dpi: 1 dot = 20
µ