
PRINTER ENGINE SERVICE MODE
17 January, 2003
5-20
1
Mode No.
(Class 1, 2, and 3)
Function / [ Setting ]
[OHP/TH Fusing]
OHP/Thick Paper Fusing Temperature Correction
(
H
eating or
P
ressure Roller)
Specifies the temperature for starting a print job.
The fusing section is already warmed up when the last print job was completed. If prints
are made on OHP or thick paper at this time, the fusing temperature tends to be higher
than the target, causing exit roller marks or a paper jam in the fusing section.
To prevent this, the print job will not start if the heating and pressure roller temperatures
are higher than the following:
(Target temperature specified by SP1-105-12, -13, -23, -24) - (Temperature specified by
this SP mode (default: 5
°
C for heating roller, 10
°
C for pressure roller))
4 H:Print
Temp
*BCU [ 0 to 20 / 0 / 1
°
C /step ]
5 P:Print
Temp
*BCU [ 0 to 20 / 0 / 1
°
C /step ]
996
6 PreJob Mode
*BCU This SP enables or disables the 30-second fusing
unit idling at the start of an OHP print job. When
enabled, idling is done even if the machine is in
the ready condition. [ 0 to 1 / 0 / 1 /step]
0: Off
1: On