
17 January, 2003
SERVICE PROGRAM MODE
5-1
Service
Tables
5. SERVICE
TABLES
5.1 SERVICE PROGRAM MODE
!
CAUTION
Before accessing the service menu, do the following:
Confirm that there is no print data in the printer buffer (the Data In LED
must not be lit or blinking).
If there is some data in the buffer, wait until all data has been printed.
NOTE:
For the machine with the optional CF expander, see section 5.2.
5.1.1 ENABLING AND DISABLING SERVICE PROGRAM MODE
NOTE:
The Service Program Mode is for use by service representatives only, so
that they can properly maintain product quality. If this mode is used by
anyone other than service representatives for any reason, data might be
deleted or settings might be changed. In such case, product quality cannot
be guaranteed any more.
Entering the Service Program Mode
There are two ways to enter the Service Program Mode.
Method 1:
Turn the machine on while pressing the On Line key and Escape key
together until the above message in the illustration appears on the display.
NOTE:
If you switch the machine off, any jobs stored on the hard disk using the
sample print and protected print features will be deleted.
Check first with the user tools to see if there are any jobs stored with these
features
(Menu key - Sample Print, or Protected Print).
Method 2:
Press the Up/Down arrow keys together for about 5 seconds, then
press the Enter key.
The above message shown in the illustration appears on the display.
NOTE:
The machine automatically goes off line when you enter the service
program mode.
16
桁×2行
LCD
Online
Menu
Jon Reset
Form Feed
Escape
Enter (#)
Power
Error
Data In
SYSTEM Ver Ver.
SYSTEM Ver Ver.
SYSTEM Ver Ver.
SYSTEM Ver Ver.
1.Service
1.Service
1.Service
1.Service
G080S904.WMF