Ricoh G-P3, Service Manual

Page: 333 / 413

13. Check that the NVRAM data is correctly downloaded.
• This procedure does not download the following data to the NVRAM:
• Total Count
• Serial Number
Address Book Upload/Download
Download
1. Prepare a formatted SD card.
2. Make sure that the write-protection on the SD card is off.
3. Turn off the main power switch of the main machine.
4. Remove the SD slot cover from SD card slot 2 at the left rear side of the machine (
 x 1).
5. Install the SD card into SD card slot 2 (for service use).
6. Turn on the main power switch.
7. Enter the SP mode.
8. Do SP5-846-051 (Backup All Addr Book).
9. Exit the SP mode, and then turn off the main power switch.
10. Remove the SD card from SD card slot 2.
11. Install the SD slot cover on SD card slot 2.
• If the capacity of SD card is not enough to store the local user information, an error message is
displayed.
• Carefully handle the SD card, which contains user information. Do not take it back to your
location.
Upload
1. Turn off the main power switch of the main machine.
2. Remove the SD slot cover from SD card slot 2 at the left rear side of the machine (
 x 1).
3. Install the SD card, which has already been uploaded, into the SD card slot 2.
4. Turn on the main power switch.
5. Enter the SP mode.
5. Service Tables
332
5