Basic Settings
MENU
DESCRIPTION
Auto Response
(Human) Sensor
When the auto response sensor does not detect anyone
operating it, the copier will be in the some Reset modes (Auto
Reset, Low Power mode, Auto Off, or SADF Auto Reset) after
the selected time in each menu. You can cancel this setting.
❐
Default: Yes (On)
Operation panel
beeper
The beeper (key tone) can be turned on or off.
❐
Default: On
Copy count display
The copy counter can be set to show the number of copies
made (count up) or the number of copies remaining to be made
(count down).
❐
Default: Up (count up)
Set date
Set time
Use to set the date and copier’s internal clock. Set the date and
clock following the touch panel display instructions.
❐
Date of the Date Stamping mode depends on these.
❐
If necessary, remember to adjust the clock for daylight saving time
(summer time), or return it to the standard time.
[
▼
Next]
Auto Reset
The copier returns to its initial condition automatically after your
job is finished. The automatic reset time can be set from 10
seconds to 180 seconds in 10 seconds steps or no auto reset
(0 second).
❐
Default: 30 seconds
Low Power Timer
The copier will automatically enter a Low Power condition after
the selected time after the last copying job has been completed.
This time can be set from 1 to 120 minutes in 1 minute steps.
❐
Default: 15 minutes
❐
The operator can activate the Low Power mode by pressing the
Clear Modes/Low Power Mode key for more than one second.
❐
Time required to return to a ready condition from the Low Power
mode is less than 30 seconds.
❐
In this mode, power consumption is reduced from less than 0.20kW
(standby) to less than 0.11 kW.
na-8
USER TOOLS
137