GTR058 Installation Manual:
Rev 22
19
Step 09: Adjusting the Travel Limit Switch:
The limit switch controls the closed position (stop point) of the gate. Moving the limit switch closer to
the hinge point of the gate (the gate post) will make the gate stop at an earlier point when closing.
Moving the limit switch away from the hinge point will make the gate stop at a later point when closing.
To adjust the limit switch, use a screwdriver to loosen the screw of Limit Switch
A
, slide to the
correct position, and then tighten the screw again (refer to fig 18)
Pull to Open Limit Switch Adjustment:
Fig 18
Please Note:
Each swing arm contains an internal thread that may separate if over extended.
If overextended “Click” may be heard, to re-connect push and screw the sliding arm Clockwise
until the arm begins to retract by hand.
Please Note:
The adjustable limit switch on each gate opener may need to be set at slightly
different positions to achieve the perfect close position for each gate.
A: Close position limit switch
By sliding this limit switch towards
the centre, you will reduce the final
closed position of the gate.
B: Open position limit switch
Factory set. Please do not adjust
without consulting Richmond staff.
