GTR058 Installation Manual:
Rev 22
16
Step 05: Affixing the Post & Gate Brackets:
Mark the bolt-hole points on the gate post and the gate. We recommend marking the middle of each
bolt slot on the Post Brackets and the Gate Bracket, this will allow slight adjustments in positioning.
Once the holes are marked, remove the post bracket and gate bracket by taking off the C-clamps.
• Drill ø10.5 mm diameter holes through the post and the gate at the marked locations.
•
Secure the post bracket assemblies to the gate posts using the M10 x 200mm bolts, nuts and
washers supplied.
•
Secure the gate brackets to eachgate using the M10 x 75mm bolts nuts and washers supplied.
•
You can cut off any part of the bolts that extend beyond the tightened nuts.
• With the gate opener fully retracted and the gate in the fully opened position, reattach the gate opener
to both brackets, using the pins and hairclip pins to secure.
• Check again that the gate swings smoothly by hand, and that the gate arm is level.
• Open the release plug on the top of the gate arm, insert the release key, and turn the key
90° anti-clockwise. This puts the opener back into automatic mode.
Pull to Open: Gate is Open
Gate
Bracket
bolted to
gate cross
member
Post Bracket Assembly
bolted to fence post
Gate
Opener
Fence
Post
Fig 13
Fig 11
Fig 12
Through the center of each of the gate bracket slots, mark the
cross member. Drill ø10.5mm holes in the marked position.
Mark the fance posts through the middle of the
bracket slots and drill ø10.5mm holes.
