RT-500-M
RHOTHETA
Page 104 of 168
User Manual
o
Confirm the setting with “OK” or leave the dialog without adopting the new value by pressing
“ESC”.
7.4.3.5 Beep Tone Decoding
Parameters of the menu “Beep Tone Decoding” control the behavior of the function “Fast Channel
Scan”, for the case that an alarm should be triggered only if an audio signal (“BeepTone”) has been
decoded.
This setting is only usable, if “Fast Channel Scan” (licensed option) is unlocked (for further information
please see 7.2.3.3).
The user can define characteristics of beep tone decoding by pressing “OK” or the hotkey “Edit Value”,
while the setting “Beep Tone Decoding” is marked by the green frame. The following dialog opens (s.
Figure 119).
Figure 119. Beep tone decoding settings
All values can be set to the default values, using the hotkey “Reset Values” (s. Figure 119, position 5).
Frequency High
defines the upper frequency for the beep tone decoding. The default value for this
setting is 900 Hz. There are two ways to change this setting: either using the “Freq. High” or the “Edit
Value” hotkey (s. Figure 119, positions 1 and 4), both of these hotkeys will open the same dialog.
Figure 120. Dialog for the upper frequency (Beep Tone Decoding)
o
Type the new value for the upper frequency into the “New Setting” field, using the DCU
number keys.
o
Press the hotkey “Set Default” to use the default value (900 Hz).
o
Confirm the setting with “OK” or leave the dialog without adopting the new value by pressing
“ESC”.