Rhino-Rack RBLW, Fitting Instruction

Page: 27 / 28

Page 27 of 28
If the balance point is correct, check the sliding lines, these must not be taut, if taut, un-splice the line
re-adjust then splice. Continue winching slowly, the boat will move upward and start to pivot around the
pivot roller, at this point the boat is above the balance point and bow will start to move downward and
forward until the gunnels contact the power roller. Continue winching slowly, the bow will move
downward and contact the front roller. Continue winching until the sliding line ring is near the front eye
nut and the boat is approximately 150mm from the front roller. Check the sliding line length, this can be
adjusted to a length, equal to the distance from the balance point to the front eye nut + 50mm.
Continue winching until the sliding line pulls the winch line down, the tie down lines will pull the transom
down onto the power roller. All lines must be taut and the boat cannot be lifted off the front and power
BP
The (BP) balance point
must be at the pivot roller
to maximum of 50mm
below the pivot roller.
Sliding lines must
not be taut.