Rhino-Rack RBLW, Fitting Instruction

Page: 26 / 28

Page 26 of 28
Clip the snap hooks Splice the
With all snap hooks connected to the eye nuts the boat should be balanced on the keel. If the winch lines
are of unequal length, the boat, when in the vertical position will be leaning and will skew on the rollers.
Winching the boat up
and line adjustments.
Turn the winch
handle clockwise.
The winch lines
will tension and
raise the front of
the boat, as the
front of the boat
raises the tie
down lines will
tension and
support the boat,
continue
winching until
the boat is
vertical and the gunnels are against the pivot roller. Check that the balance point marked on the boat is
inline with the pivot roller to a maximum of 50mm below the roller, if the position is incorrect lower the
boat and adjust the tie down lines by un-splicing, move the snap hook and splice. Recheck the balance
point to pivot roller before winching further.
snap
hook
and ring
onto the
winch
lines.
to front eye nuts.
Winch lines must
be same length.