Rhino-Rack RBLW, Fitting Instruction

Page: 28 / 28

Page 28 of 28
Unloading the boat.
Hold the winch handle and disengage the winch ratchet, turn the winch anti-clockwise, the power roller
being in contact with the gunnels drives the boat backwards off the loader. When the balance point of
the boat is at the power roller, the boats bow will start to lift, the boat will move downwards to contact
the power roller and the tie down lines will be taut.
Continue winching, the boat will move down and pivot around the pivot roller, this will continue until
the boat is vertical and supported on the tie down lines, continue winching, the boat will move away
from the pivot roller and onto the ground. Disconnect the snap hooks from the eye nuts.
To stow the lines on the vehicle when the boat is not loaded, snap the winch line hook to the tie down
line snap hook and wind in the winch until the lines are taut. Remove the H frame.
For extra safety, strap the boat to the roof rack using two Ratchet straps.
Manufactured by Rhino-Rack
22 Hanson Pl, Eastern Creek,
NSW 2766, Australia
RHINO-RACK No: RR72
Issue 02
Issue Date 10/05/19